Rear Wheel Speed Sensor: Installation
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1992 Eagle Premier, 1992 Dodge Monaco, 1992 Dodge Dynasty, 1992 Chrysler New Yorker Fifth Avenue, and 1992 Chrysler New Yorker. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Be sure to coat sensor with high-temperature multipurpose grease before installing. Tighten sensor screw to 60 INCH lbs. (7 N.m). There is no air gap adjustment.
CAUTION:
Proper installation of wheel speed sensor cables is critical to system operation. Ensure cables are installed in retainers. Failure to install cables in retainers may result in contact with moving parts and/or over-extension of cables, causing an open circuit.