DRB-II Test Functions: Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 1992 Eagle Premier, 1992 Dodge Monaco, 1992 Dodge Dynasty, 1992 Chrysler New Yorker Fifth Avenue, and 1992 Chrysler New Yorker. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
DO NOT
touch DRB-II keypad during DRB-II power-up sequence or an error message will result.
- In order to perform diagnostic tests using the DRB-II, the DRB-II must be in the ABS MENU. At the ABS MENU, fault codes and DRB-II test functions can be accessed.
- To reach ABS MENU, turn ignition off. Attach DRB-II to Chrysler Collision Detection (CCD) bus diagnostic connector. Connector is located under driver's side of instrument cluster. Turn ignition switch to RUN position.
- All DRB-II character positions will illuminate and copyright information will appear on screen for a few seconds. If the DRB-II screen display is blank or if any error messages appear, refer to DRB-II PROBLEMS & ERROR MESSAGES .
- After a few seconds, the DRB-II menu will appear. At DRB-II menu, press "4" (SELECT SYSTEM) key to enter diagnostic test program. Press down arrow 3 times to change menu display.
- Select "5" (ABS) key to enter ABS part of the DRB-II program. After a few seconds, the ABS MENU will appear. The screen will display a menu of the DRB-II test categories for the anti-lock brake system. Press down arrow 3 times to view rest of menu.
- At this point, you have reached the ABS menu. At ABS menu of anti-lock brake system diagnostic program, specific test functions programmed into DRB-II cartridge can be performed. The following DRB-II modes can be accessed: SYSTEM TEST, READ FAULTS, STATE DISPLAY, ACTUATOR TEST and ADJUSTMENTS.