LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1992 >> Sundance Base, 2D Hatchback, 2.2 D, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Axle Hub Bearings >> Installation

Axle Hub Bearings: Installation

  1. To install, reverse removal procedure. Seat new races into drum or hub. Pack bearings using multi-purpose grease. Install inner bearing and new seal.
    NOTE: DO NOT  reuse old grease seals.
  2. Clean and inspect spindle. Apply a thin coat of wheel bearing grease to polished surfaces. Install drum or hub on spindle. Install outer bearing, washer and adjusting nut.
  3. Tighten adjusting nut to 20-25 ft. lbs. (27-34 N.m). Back off adjusting nut 1/4 turn. Finger tighten adjusting nut. Position nut lock with slots in line with cotter pin hole on spindle. Install cotter pin, grease cap and wheel.
scientia non olet · About LEMON Manuals