LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1991 >> Laser RS Turbo, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [R] & 2.0L 4-CYL Turbo - VIN [U] >> Removal & Installation >> Engine >> Removal

Removal & Installation: Engine: Removal

  1. Release fuel pressure. See FUEL PRESSURE RELEASE in this article. Drain cooling system. Remove hood and radiator. Remove transaxle. See appropriate CLUTCHES or TRANSMISSION article in TRANSMISSION SERVICING.
  2. Disconnect necessary control cables, electrical connections, vacuum hoses and coolant hoses. Disconnect fuel lines. Remove power steering pump and A/C compressor with hoses attached, and secure aside.
  3. Disconnect exhaust pipe at exhaust manifold. Disconnect power steering hose clamp near front mount, near timing belt cover.
  4. Support engine with engine hoist. Remove through bolt from engine mount near timing belt cover and rear engine mounts. DO NOT  remove engine mounts from frame. Remove engine assembly.
CAUTION: If removing lower engine mounts from frame, mark position of mount before removing. Mounts must be installed in original location to provide proper positioning of engine.
scientia non olet · About LEMON Manuals