LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1990 >> Horizon Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Disc Brake Caliper - Rear (Except MONACO & Premier) >> Reassembly

Disc Brake Caliper - Rear (Except MONACO & Premier): Reassembly

  1. Dip new piston seal in clean brake fluid and gently work seal into groove until seated. Coat new piston boot with clean brake fluid, leaving a generous amount inside boot.
  2. Position dust boot over piston. Install piston, pushing it past seal, until it bottoms in bore. Position boot in counterbore. Using a hammer and dust boot installer, drive boot into counterbore.
  3. Install new bushings on caliper by pressing in on bushings until seated. Ensure bushing flanges extend evenly over caliper casting. Clean and lubricate caliper-to-mounting bracket contact areas. Install caliper. Fill and bleed system. Check brake operation.
scientia non olet · About LEMON Manuals