LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1990 >> Colt DL, 1.5 X, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Testing >> Wheel Bearing (Colt Vista 4WD) >> Installation

Wheel Bearing (Colt Vista 4WD): Installation

  1. Using Bearing Installer (C-3893), install inner bearing in arm. Using Seal Installer (MB990799), install seal in inner arm, with concave side facing outward.
  2. Coat seal lip with grease. Install dust cover. If backing plate was removed, apply semi-drying sealant to flange area of inner arm. Install backing plate. Tighten bolts to specification. See the TORQUE SPECIFICATIONS (COLT VISTA)  table at end of article.
  3. Using Dust Cover Installer (MB990799), install dust cover on axle shaft. Concave side of dust cover must face splined end of axle shaft. Using bearing puller/installer and press, install bearing on axle shaft, with seal surface facing toward flange side of axle shaft.
  4. Install axle shaft in inner arm. Install companion flange and new retaining nut. Using axle holder, tighten nut to specification. See TORQUE SPECIFICATIONS (COLT VISTA)  table at end of article. Check axle shaft end play. To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals