Installation (2WD Ram-50)
To install, reverse removal procedure. Tighten wheel bearings to 22 ft. lbs. (30 N.m). Loosen nut and then retighten to 72 INCH lbs. (8 N.m). Install cotter pin. If pin does not align, loosen nut 30 degrees maximum.
To install, reverse removal procedure. Tighten wheel bearings to 22 ft. lbs. (30 N.m). Loosen nut and then retighten to 72 INCH lbs. (8 N.m). Install cotter pin. If pin does not align, loosen nut 30 degrees maximum.