LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1989 >> Colt Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.8L 4-CYL - VIN [T] & 2.0L 4-CYL - VINS [D,V] >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

To install, reverse removal procedure. Ensure that all pipes and hoses are cleared when lowering engine assembly into compartment. Tighten mounting bolts and nuts to specification with weight of engine on insulators. Replace all fluids and adjust all cables and linkages.

Fig 1: Typical Connector Location (Colt Vista Shown)
G90B08803Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.


  1. To install, reverse removal procedure. Support rod (roll rod) must be installed in original direction with marked side facing downward.
  2. Perform final tightening of mounting bolts and nuts with weight of engine on insulators. Replace all fluids and adjust all control cables and linkages.
Fig 1: Typical Eng/Transaxle Mounting Arrangement (Colt Wagon Shown)
G90D08804Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.


To install, reverse removal procedure. Ensure that all wiring and hoses are cleared when lowering engine assembly into compartment. Tighten mounting bolts and nuts to specification with weight of engine on insulators. Replace all fluids and adjust all cables and linkages.

scientia non olet · About LEMON Manuals