LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1989 >> Colt Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VIN [X] & 1.6L 4-CYL - VINS [Y,Z] >> Removal & Installation >> Engine >> Installation (Colt Wagon)

Installation (Colt Wagon)

  1. To install, reverse removal procedure. On M/T models, support rod (roll rod) must be installed in original direction with marked side facing downward.
  2. With engine installed, install all engine mount bolts loosely. Perform final tightening of mounting bolts and nuts with weight of engine on insulators. Replace all fluids and adjust all control cables and linkages.
CAUTION: Drive axle shaft retainer rings should be replaced whenever drive axle shafts are removed from transaxle.
scientia non olet · About LEMON Manuals