LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1989 >> Colt Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 1.5L 4-CYL - VIN [X] & 1.6L 4-CYL - VINS [Y,Z] >> Engine Cooling >> Water Pump >> Installation

Water Pump: Installation

To install, reverse removal procedure using new gasket and "O" ring. Install "O" ring on coolant pipe and then apply water to "O" ring. DO NOT  apply grease or oil to "O" ring. Ensure bolts are installed in original location.

NOTE: For further information on cooling systems, see ENGINE COOLING SYSTEMS article at end of this section.
BELT TENSION SPECIFICATIONS

Application (1) New Belt Deflection In. (mm)
Colt
1.5L .22-.28 (5.6-7.1)
1.6L .28-.34 (7.1-8.6)
Colt Wagon (1.5L) .22-.28 (5.6-7.1)
(1) Measured with 22 lbs. (10 kg) pressure applied midway on belt.
scientia non olet · About LEMON Manuals