Horizon & Omni
- Remove 2 cluster bezel lower attaching screws. Allow bezel to drop slightly (to free upper locating pins) and remove from cluster mask. Remove 4 screws attaching cluster to base panel. Pull cluster rearward and disconnect speedometer cable and wiring connector. Remove cluster assembly.
- To remove fuel gauge and tachometer, remove cluster bezel. Unscrew trip reset knob. Remove mask/lens lower attaching screws. Allow mask/lens to drop slightly and remove. Remove screws attaching gauge to cluster. Remove fuel gauge/tachometer assembly.
- To remove speedometer, remove cluster bezel and mask/lens. Remove screws attaching speedometer to cluster housing. Pull speedometer rearward and disconnect cable.
- To remove temperature gauge, oil pressure gauge or voltmeter, remove cluster bezel and mask/lens. Remove screws attaching gauge assembly to cluster. Remove 3-gauge assembly. Replace warning light bulbs if necessary.
- To remove printed circuit, remove cluster assembly. Remove tachometer drive module (if used). Remove light sockets and printed circuit board screws. To install components, reverse removal procedure.