LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1988 >> Colt Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Standard >> Removal & Installation >> Standard Instrument Cluster R & I >> Daytona & LeBaron Convertible/Coupe

Daytona & LeBaron Convertible/Coupe

  1. Remove 5 screws attaching top of cluster bezel to instrument panel. Pull bezel rearward to disengage 3 clips on bottom of bezel. Remove bezel. Remove 4 screws attaching cluster to base panel. Pull cluster assembly rearward.
  2. Reach under cluster and disconnect wiring harness. Remove cluster assembly. To remove tachometer, remove cluster bezel and 5 screws holding cluster mask. Remove tachometer attaching screws. Pull tachometer rearward to remove.
  3. To remove speedometer/odometer, remove cluster bezel and 5 screws holding cluster mask. Remove 3 screws attaching speedometer to cluster. Pull speedometer rearward to disengage from gauge pins.
  4. To remove voltmeter and fuel gauge, remove cluster bezel and mask. Remove tachometer. Remove screws attaching gauge assembly to cluster. Pull rearward to remove gauge assembly.
  5. To remove temperature and oil pressure gauge, remove cluster bezel and mask. Remove speedometer. Remove screws attaching gauge assembly to cluster. Pull rearward to remove gauge assembly.
  6. To remove printed circuit, remove cluster. Remove gauge alert module (if used) and tachometer drive module. Remove light sockets and screws securing printed circuit board. To install components, reverse removal procedure.
scientia non olet · About LEMON Manuals