Brake Booster - RWD Models: Removal
- Remove nuts attaching master cylinder to power brake unit. Carefully slide master cylinder off mounting studs and allow to rest against fender shield. Disconnect vacuum hose from power brake.
- From under dash panel, position a small screwdriver between center tang on retainer clip and pin in brake pedal. Rotate screwdriver enough to allow retainer clip center tang to pass over end of brake pedal pin and pull retainer clip from pin. Discard retainer clip.
- Remove lower pivot retaining bolt and nut. Remove 4 power brake attaching nuts. Rotate linkage as necessary and remove power brake unit from vehicle. Remove pivot bushing and sleeve for reuse.