LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1985 >> Conquest 2.6 H, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VINS [H,N] >> Removal & Installation >> Rocker Assembly & Camshaft >> Installation

Rocker Assembly & Camshaft: Installation

  1. Lubricate camshaft lobes and camshaft bearing journals and install camshaft to cylinder head. Install rocker arm assembly to cylinder head. Insert camshaft bearing cap bolts and tighten to 84 INCH lbs. (10 N.m) in sequence of center, 2, 4, front and rear. Repeat sequence, tightening to specification.
  2. Install camshaft sprocket and distributor drive gear to camshaft. Tighten camshaft locking bolt. Adjust valve clearance to specification. To complete installation, reverse removal procedure.
Fig 1: Exploded View of Rocker Assembly Check rocker arms for wear or damage on all contact surfaces.
G82075
scientia non olet · About LEMON Manuals