LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1985 >> Conquest 2.6 H, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.6L 4-CYL - VIN [E] & 2.6L 4-CYL Turbo - VINS [H,N] >> Engine Cooling >> Water Pump >> Removal & Installation

Removal & Installation

Drain cooling system and disconnect battery. Remove fan shroud if so equipped and remove lower radiator hose. Remove drive belt, cooling fan, fan clutch and pulley. Remove water pump. To install, reverse removal procedure using new gasket.

NOTE: For information on cooling system capacities and other cooling components, see appropriate article in ENGINE COOLING SYSTEMS section.
scientia non olet · About LEMON Manuals