LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1984 >> Conquest Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Instrument Panel - Electronic) >> Testing >> Pulse Generator

Pulse Generator

WARNING: This page is about a different car, the 1987 Chrysler Conquest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove pulse generator from vehicle. Apply 12 volts to terminal No. 1 (positive) and ground terminal No. 3 (negative). Also connect a 3000-10,000 ohm resistor in-line between terminal No. 2 and power supply to terminal No. 1. See Fig 1 .
  2. Install a voltmeter between terminals No. 2 and No. 3. Rotate pulse generator and verify that one revolution equals 4 meter deflections.
Fig 1: Hook-up For Pulse Generator Testing
G64918Courtesy of CHRYSLER MOTORS.
scientia non olet · About LEMON Manuals