LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1984 >> Conquest Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [D] & 2.6L 4-CYL - VINS [E,H] >> Removal & Installation >> Rocker Assembly & Camshaft >> Removal

Rocker Assembly & Camshaft: Removal

  1. Remove air cleaner, breather hoses and purge line. Remove fuel pump and line. Disconnect spark plug wires and remove rocker cover. Remove breather and semi-circular seal.
  2. Slightly loosen camshaft sprocket bolt and turn engine to TDC of compression stroke on No. 1 cylinder. Make mating mark on timing chain and camshaft sprocket.
  3. Remove camshaft sprocket and hang sprocket on sprocket holder provided on timing chain lower front cover. Remove distributor drive gear, camshaft bearing caps, rocker arms and rocker shafts as an assembly. Remove camshaft.
NOTE: If front and rear bearing cap bolts are left inserted, rocker shaft assembly can be removed without separation of pieces.
scientia non olet · About LEMON Manuals