Removal (Ram-50 Pickup)
- Disconnect negative battery cable. Remove hood and air cleaner. Disconnect heater and brake booster vacuum hoses. Disconnect fuel hoses and accelerator cable.
- Disconnect wiring from starter, alternator, coil and water temperature and oil pressure sending units. Remove radiator assembly. Disconnect clutch cable and remove front exhaust pipe.
- Remove power steering pump, if equipped. Remove undercover and other protective transmission covers, if equipped. Disconnect speedometer cable, back-up light harness and 4WD indicator light switch (if equipped).
- Mark for reference, and remove drive shafts. Remove gear shift lever assembly. Support transmission, detach rear insulator from transmission and remove crossmember.
- Detach and remove transfer case mounting bracket and support insulator from transfer case. Remove front engine insulator mounting nuts. Attach lifting cables. With front of engine tilted upward, remove engine-transmission assembly.