LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1984 >> Conquest Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L 4-CYL - VIN [D] & 2.6L 4-CYL - VINS [E,H] >> Overhaul >> Piston & Connecting Rod Assembly >> Installation

Piston & Connecting Rod Assembly: Installation

  1. To install, lubricate all internal surfaces with engine oil before installation. Make sure front mark on piston head faces front of engine.
  2. Use a ring compressor to compress rings (without changing their position) and install piston and connecting rod assembly into cylinder block in their original position.
  3. Tap lightly on piston dome with wooden handle tool while guiding connecting rod onto crankshaft. Install rod cap onto proper piston and connecting rod assembly with bearing insert notches on same side. Tighten attaching bolts and install cylinder head, rear main seal housing and oil pan.
scientia non olet · About LEMON Manuals