Front Disc Brake Rotor: Installation
- Install rotor on hub, and tighten bolts. Hold outer bearing inner race with holding tool (MB990776-A), and press hub into knuckle. Install new inner oil seal, using installer (DT-1007-D and C-4171).
- Slide drive shaft into proper position, and install knuckle assembly by reversing removal procedures.
NOTE:
If removal or replacement of bearings or races is necessary, see the SUSPENSION - FRONT
article in the SUSPENSION Section.
To install, reverse removal procedures. Tighten hub-to-rotor bolts. Bleed brake system if necessary, and adjust wheel bearings. See appropriate article in the SUSPENSION Section.
- For Challenger & Sapporo, see: SUSPENSION - FRONT .
- For 2WD Ram-50, see: SUSPENSION - FRONT (2WD) .
- For 4WD Ram-50, see: SUSPENSION - FRONT (4WD) .