LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1983 >> Sapporo Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc & Drum >> Overhaul >> Rear Disc Brake Caliper >> Disassembly (Challenger & Sapporo)

Disassembly (Challenger & Sapporo)

  1. Remove cap ring. Take off lever cap. See Figure. Remove retaining ring and spring. Pull out parking lever assembly. Using pliers if necessary, rotate automatic adjuster spindle slightly. Pull out assembly.
  2. Using Bearing Installer/Remover (MB990665), pull bearings from caliper. Remove piston boot. Working through vacant area created by adjuster spindle removal and using a blunt drift, force piston from caliper. Remove piston seal without damaging caliper bore or seal groove.
scientia non olet · About LEMON Manuals