Removal - Front Wheel Drive
- Place gearshift lever in "1" position. Remove left upper and lower cluster bezel screws. Remove bezel and cluster mask by prying them off remaining clips.
- Remove 8 screws attaching upper right bezel. Remove screws securing instrument panel top cover. Lift rear edge of top cover and remove 2 screws attaching cluster housing to base panel. Remove 2 screws attaching cluster housing to base panel from lower cluster.
- Lift back edge of top cover and slide cluster housing rearward. Reach behind cluster and disconnect right printed circuit connector, speedometer cable and left printed circuit connector. Gauges, trip computer, message center and voltage limiter can now be removed by removing mounting screws and wiring connectors.