Removal (Aries & Reliant)
- Place gearshift lever in "1" position. Remove instrument panel cover trim strip. Remove 3 screws securing cluster bezel, and remove bezel by prying it off retaining clips. Remove 7 screws attaching upper right bezel.
- Remove 4 screws securing instrument panel top cover. Lift rear edge of top cover and remove 2 screws attaching upper trim strip retainer and cluster housing to base panel. Remove trim strip retainer. Remove 2 screws attaching cluster housing to base panel.
- Lift back edge of top cover and slide cluster housing rearward. Reach behind cluster and disconnect right printed circuit connector, speedometer cable and left printed circuit connector. Service gauges by removing mounting screws and wiring connectors.