LEMON Manuals: Even more car manuals for everyone
Home >> Plymouth >> 1979 >> Arrow Base, Standard Trans >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Sun & Moon Roofs - Electric >> Removal & Installation >> Sliding Panel, Halo Moulding Or Sun Shade >> Removal (General Motors - Sun Shade

Removal (General Motors - Sun Shade

  1. On regular sunroof models, open roof panel slightly and pry down front portion of headlining panel. Open sunroof to within 3" of fully open position to allow headlining frame to fall free of roof panel rear hooks.
  2. Pull headlining panel forward out of side guide rail tracks. Close sunroof and push headlining panel as far rearward as possible.
  3. On all sunroof models, remove outer and loosen inner retaining screws at both front guide shoe assemblies. Rotate guide assemblies so that slide portion is disengaged from track. Pull both rear slide and cable assemblies inward and out of retainer hole. Lift and remove sunroof up and out through top of vehicle.
    Fig 1: General Motors Sunroof Wiring Diagram
    G09348665Courtesy of NOT AVAILABLE