Cylinder Head Gasket: Remove & Replace
WARNING: This page is about the 505 SW8, 2.2 E, which is a different variant/trim than selected.
Includes: Remove carbon and check surfaces for warpage. Includes adjust Valves (where applicable) and clean and adjust Spark Plugs.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| In-Line4,Gas,2.2L Eng,Normally Aspirated | 7.4 | B | ||
| In-Line4,Gas,2.2L Eng,Turbocharger, w/Intercooler | 7.9 | B | ||
| In-Line4,Gas,2.2L Eng,Turbocharger, w/o Intercooler | 7.4 | B | ||
| Additional Procedure: CYLINDER HEAD GASKET: Remove & Replace: | ||||
| Where Air Cond interferes add | 0.5 | B | ||
| Where Pwr Strg interferes add | 0.5 | B | ||
| Combination Procedure: CYLINDER HEAD: Disassemble & Assemble: | ||||
| Use Necessary Clock Time. D&A for Sublet machine operations. | B | |||
| Combination Procedure: ROCKER ARM &/OR SHAFT: Overhaul: | ||||
| Gas | 1.0 | B | ||
| Combination Procedure: VALVE GUIDE: Remove & Replace: | ||||
| Eight | 2.5 | A | ||
| Four | 1.5 | A | ||
| One | 0.4 | A | ||
| Twelve | 3.3 | A | ||