LEMON Manuals: Even more car manuals for everyone
Home >> Opel >> 1975 >> Opel 2D Wagon, Standard Trans >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel & Column Switches >> OPEL >> Turn Signal Switch & Ignition Lock >> Installation

Turn Signal Switch & Ignition Lock: Installation

  1. When installing a new turn signal switch, also use a new bearing and snap ring in the switch assembly. Install switch and lock assemblies in position using new shearhead bolts.
  2. Disconnect slide-off base, replace upper half of turn signal switch housing cover and loosely reattach slide-off base. Attach steering mast jacket at front of dash panel.
  3. Torque slide-off base attaching nuts. Install lower half of steering column cover and reconnect wire harness. Install steering wheel.
scientia non olet · About LEMON Manuals