1970 Gt
- Remove hood and disconnect battery cables. Drain cooling system and remove assembly including hoses. Using suitable tool (J-21709) remove shift linkage. Remove air cleaners. Withdraw rod from carburetor and rear support.
- From engine, disconnect fuel line, control cables for carburetors and heater, heater hoses and starter wires, alternator, distributor, and back-up light switch on transmission.
- Remove oil filter and its housing. Disconnect exhaust pipe from exhaust manifold. Remove drive shaft.
- Using suitable equipment (see Fig 1), attach engine harness. Loop cable around water pump housing and front exhaust manifold mounting flange. Secure ends to bar.
Courtesy of NOT AVAILABLE
- Loop a second cable around crankcase between clutch housing and oil pan. Secure ends to bar.
- Disconnect transmission crossmember from transmission and frame. Disconnect engine crossmember from engine and frame.
- Pull engine toward front as far as possible and carefully lift engine from car.