Test AE: Tachometer Inaccurate Or Inoperative
- If Instrument Panel Cluster (IPC) system diagnostic system check has been performed, go to next step. If IPC system diagnostic system check has not been performed, perform IPC system diagnostic system check. See INSTRUMENT PANEL CLUSTER SYSTEM DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Turn ignition switch to OFF position. Connect scan tool to Data Link Connector (DLC). DLC is located below left side of instrument panel, to right of steering column. See Figure . Turn ignition switch to START position. Using scan tool, observe ENGINE SPEED parameter in PCM ENGINE 1 data list. If scan tool display matches tachometer display, go to DIAGNOSING INTERMITTENTS . If scan tool display does not match speedometer display, go to next step.
- Replace IPC. See INSTRUMENT PANEL CLUSTER under REMOVAL & INSTALLATION. After repair, go to next step.
- Operate system to verify repair. If system does not operate properly, go to step 2 . If system operates properly, system is okay.