DTC C1286: EBCM/EBTCM Turned On Red Brake Warning Indicator
WARNING: This page is about a different variant/trim than selected.
- Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK. After performing diagnostic system check, go to next step.
- Turn ignition on, with engine off. Install scan tool. Using scan tool, display DTCs. If any other DTCs are set with DTC C1286 as current or history, go to step 4) . If no other DTCs are set with DTC C1286 as current or history, go to next step.
- Using scan tool, clear DTC C1286.
- Any ABS mechanical DTC that commands Red BRAKE warning indicator to illuminate will also cause DTC C1286 to be stored in EEPROM during shutdown. ABS mechanical DTCs include C1238, C1241, C1242, C1246 and C1251. Certain ABS electrical DTCs will also command Red BRAKE warning indicator to illuminate if motors are not in home position. These ABS electrical DTCs include C1214, C1216, C1218, C1255, C1256, C1257, C1258, C1261, C1262, C1263, C1264, C1265 and C1266. Any other ABS mechanical or electrical DTCs must be serviced before servicing DTC C1286.