Electronic Brake Control Module/Electronic Brake & Traction Control Module (EBCM/EBTCM) & Brake Pressure Modulator Valve (BPMV) Assembly: Installation
WARNING: This page is about a different car, the 1999 Buick Regal and 1999 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Ensure brakelines are installed in original locations. Ensure EBCM/EBTCM electrical connector tab is locked down. Tighten bolts, nuts and brakelines to specification. See TORQUE SPECIFICATIONS .
- If NEW BPMV assembly is being installed, ensure shipping plugs are removed from valve openings. Refill brake master cylinder reservoir, bleed brakes and check for leaks. See BLEEDING BRAKE SYSTEM .
- Using scan tool, perform DIAGNOSTIC SYSTEM CHECK . Check for any Diagnostic Trouble Codes (DTCs) that have been set. Diagnose and repair as necessary.