Testing Procedure
WARNING: This page is about a different car, the 1999 Buick Regal and 1999 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Verify proper stoplamp switch operation using the Data List of the scan tool. As the brake is applied, the data list should display the stoplamp switch on within 1 inch of travel.
- Perform DIAGNOSTIC SYSTEM CHECK . After performing diagnostic system check, go to next step.
- Turn ignition on, with engine off. Using scan tool, display ABS/TCS DTCs. If DTC C1291 is set as history or current, go to DTC C1291. If DTC C1291 is not set as history or current, see INTERMITTENTS & POOR CONNECTIONS under DIAGNOSIS & TESTING.