Testing Procedure
WARNING: This page is about a different car, the 1999 Buick Regal and 1999 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- Perform DIAGNOSTIC SYSTEM CHECK . After performing diagnostic system check, go to next step.
- Turn ignition off. Disconnect EBCM/EBTCM harness connector. Check EBCM/EBTCM and harness connector for damaged, pushed out or miswired terminals. Repair as necessary and go to next step. If no damage if found, go to next step.
- Reconnect all connectors. Using scan tool, clear DTCs. Test drive vehicle while monitoring ABS data. If DTC resets, go to next step.
- Replace EBCM/EBTCM.