LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1999 >> Intrigue GL, 3.5 H >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel - Analog >> Symptom Tests >> Chime Inoperative

Chime Inoperative

  1. Start engine. Firmly depress brake pedal. Shift vehicle into Drive. Release parking brake. Observe Daytime Running Lights (DRL) operation. Shift vehicle into Park and turn engine off. If DRLs come on when vehicle is shifted into drive, go to next step. If DRLs do not come on when vehicle is shifted into drive, go to step  7 .
  2. Perform BCM DIAGNOSTIC SYSTEM CHECK in BODY CONTROL MODULES - INTRIGUE article. Go to next step.
  3. Connect scan tool to DLC and check for PCM Diagnostic Trouble Codes (DTCs). If DTCs are set in PCM memory, go to appropriate DTC repair procedure in SELF-DIAGNOSTICS - GASOLINE - EXCEPT METRO, PRIZM & TRACKER article in ENGINE PERFORMANCE. If DTCs are not present, go to next step.
  4. Select BCM DATA DISPLAY INPUTS and monitor PARK BRAKE SWITCH input signal status. Apply and release parking brake. If PARK BRAKE SWITCH status is on with parking brake applied, go to step  6 . If PARK BRAKE SWITCH status is off with parking brake applied, go to next step.
  5. Turn ignition off and remove scan tool from vehicle. Disconnect BCM connector C-1. Connect test light between BCM connector C-1 terminal D5 (Orange/Black wire) and battery positive voltage. See Figure . See WIRING DIAGRAMS  . If test light is off, go to step  10 . If test light is on, go to step  8 .
  6. Disconnect scan tool from DLC. Turn ignition off. Reconnect all disconnected components and connectors. Apply parking brake and close all vehicle doors. Start engine. Firmly depress brake pedal. Shift vehicle into Drive, noting chime operation. Release parking brake, noting chime operation. Shift vehicle into Park and turn engine off. If chime sounded with parking brake on and vehicle in drive, go to step  9 . If chime did not sound with parking brake on and vehicle in drive, go to step  10 .
  7. Repair open or poor connection in Light Blue wire between DRL module and parking brake switch. After repairs, go to step  11 .
  8. Repair open or poor connection in Orange/Black wire between DRL module and BCM. After repairs, go to step  11 .
  9. System is okay. Recheck operation and go to step  11 .
  10. Replace and reprogram BCM. See BODY CONTROL MODULES - INTRIGUE article. After repairs, go to next step.
  11. Turn ignition off and reconnect all disconnected components and connectors. Connect scan tool to DLC and check for BCM DTCs. If BCM DTCs are present, go to appropriate DTC diagnosis and repair procedure in BODY CONTROL MODULES - INTRIGUE article. If no IPC DTCs are present, system is okay.
scientia non olet · About LEMON Manuals