LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1999 >> Cutlass GL, 3.1 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Front Suspension) >> Torque Specifications

Torque Specifications

WARNING: This page is about a different car, the 1997 Pontiac Grand Am, 1997 Oldsmobile Cutlass, 1997 Oldsmobile Achieva, 1997 Chevrolet Malibu, and 1997 Buick Skylark. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Axle Shaft Nut 185 (251)
Ball Joint
To Control Arm (Replacement Bolt/Nut) (1)
To Steering Knuckle (Nut) (2) 41 (56)
Brake Caliper Bolt 38 (52)
Hub & Bearing Assembly Bolt 70 (95)
Lower Control Arm-To-Frame Bolt
Front 89 (120)
Rear 125 (170)
Stabilizer Bar
To Control Arm (Nut) 15 (20)
To Crossmember (Bolt) 22 (30)
Strut Assembly
To Steering Knuckle (Bolt) 133 (180)
To Upper Body Mount (Nut) 18 (24)
Rod (Shaft) Nut 52 (70)
Suspension Support Bolt 89 (120)
Tie Rod End Nut (2) 44 (60)
Wheel Lug Nut 100 (136)
(1) Tighten to specification in service ball joint kit.
(2) Tighten nut to specification, then tighten nut further only as far as necessary to align cotter pin hole.