LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1999 >> Cutlass GL, 3.1 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Front Suspension) >> Removal & Installation >> Stabilizer Bar >> Removal

Stabilizer Bar: Removal

WARNING: This page is about a different car, the 1997 Pontiac Grand Am, 1997 Oldsmobile Cutlass, 1997 Oldsmobile Achieva, 1997 Chevrolet Malibu, and 1997 Buick Skylark. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle. Allow suspension to hang free. Remove wheels. Disconnect stabilizer bar from lower control arms. Disconnect stabilizer bar from frame.
  2. Remove rear and center suspension support assembly bolts. See Figure. Loosen, but DO NOT remove, bolt securing front of suspension support assembly. Remove stabilizer bar. Replace worn, damaged or deteriorated bushings.
scientia non olet · About LEMON Manuals