LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Regency >> Repair and Diagnosis >> Drivelines & Axles >> AXLE SHAFTS - FRONT WHEEL DRIVE - "C", "G" & "H" Bodies >> Removal, Disassembly, Reassembly & Installation >> Fwd Axle Shafts >> Installation

Fwd Axle Shafts: Installation

  1. To install axle shaft, reverse removal procedure. Lubricate tripot housing seal surface with clean transmission fluid. Push axle shaft into transaxle. Ensure axle shaft is seated fully by pulling outward on inner tripot joint housing. DO NOT pull outward on axle shaft as damage may occur.
  2. Install and tighten ball joint, knuckle, hub and bearing assembly bolts to specification. See TORQUE SPECIFICATIONS  . Ensure a NEW cotter pin is installed on ball joint retaining nut.
scientia non olet · About LEMON Manuals