LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Intrigue Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the master cylinder reservoir. Refer to MASTER CYLINDER RESERVOIR .
  2. Bench bleed air from master cylinder. Install the master cylinder.
  3. Install the master cylinder mounting nuts. See TORQUE SPECIFICATIONS .
  4. Connect the fluid level sensor electrical connector.
  5. Connect the brake pipes to the master cylinder. Tighten the master cylinder tube nuts to 11 ft. lbs. (15 N.m).
  6. Fill the master cylinder reservoir with brake fluid.
  7. Bleed the brake system. Refer to BLEEDING .
scientia non olet · About LEMON Manuals