LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Intrigue Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Fluid Level Sensor >> Removal

Fluid Level Sensor: Removal

  1. Disconnect the electrical connector from the fluid level sensor (1). See Fig 1.
  2. Remove the fluid level sensor (1). Use needle nose pliers in order to compress the switch locking tabs at the outboard side of the master cylinder. See Fig 1.
  3. To install, reverse removal procedures.
Fig 1: Removing Fluid Level Sensor
G00208953Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals