LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Cutlass GL >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Anti-Lock Brake System) >> Diagnostic Trouble Codes (DTCS) >> DTC C1282: Calibration Malfunction

DTC C1282: Calibration Malfunction

WARNING: This page is about a different car, the 1997 Oldsmobile Cutlass and 1997 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform diagnostic system check. See DIAGNOSTIC SYSTEM CHECK  . After performing diagnostic system check, go to next step.
  2. Turn ignition on, with engine off. Install scan tool. Using scan tool, display DTCs. If DTC C1282 is set as current, go to next step. If DTC C1282 is not set as current, go to step 4).
  3. Replace EBCM/EBTCM. After repairs, perform DIAGNOSTIC SYSTEM CHECK  .
  4. Malfunction is not currently present. An intermittent DTC C1282 may be caused by a bad cell in EEPROM that is sensitive to temperature changes. If DTC C1282 has been set more than once, but is intermittent, replace EBCM/EBTCM. Frequency of malfunction can be determined by using enhanced diagnostic function of scan tool.
scientia non olet · About LEMON Manuals