Brake Caliper/Cylinder
WARNING: This page is about a different car, the 1997 Oldsmobile Cutlass and 1997 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
Raise and support vehicle. Attach a clear hose to specified bleeder valve and submerge other end of hose in a container of clean brake fluid. Open bleeder valve. Allow fluid to flow until no air bubbles are seen in hose. Tap lightly on caliper or backing plate to free trapped air. Close valve and repeat procedure on remaining bleeder valves:
- Right Rear
- Left Rear
- Right Front
- Left Front