LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1998 >> Cutlass Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

  1. Liberally coat inner diameter of bushings with silicone grease. Install caliper. Install caliper bolts and bushings. See Figure . If bolts slide through bushings using hand pressure, go to next step. If bolts do not slide through bushings using hand pressure, remove bolts and bushings. Clean bores with denatured alcohol. Inspect bores for corrosion, replace as necessary. Lubricate and install bushings.
  2. Tighten caliper bolts to specification. See TORQUE SPECIFICATIONS  . If brake hose was not disconnected, go to next step. If brake hose was disconnected, connect brake hose to caliper. Tighten fitting bolt to specification. Bleed brake hydraulic system. See BLEEDING BRAKE SYSTEM  .
  3. Apply brakes several times to seat pads. Install wheels, aligning marks made during removal. Tighten wheel lug nuts to specification. Lower vehicle. Fill brake fluid reservoir. Road-test vehicle.
scientia non olet · About LEMON Manuals