Removal & Installation

Remove caliper and wire aside. See FRONT BRAKE CALIPER . Mark rotor in relation to hub for installation reference. Remove rotor. To install, reverse removal procedure. Tighten nuts and bolts to specification. See TORQUE SPECIFICATIONS .

NOTE: Manufacturer does not recommend resurfacing rotors when replacing brake pads. Resurface rotors only when there is a brake pulsation complaint or scoring greater than .060" (1.5 mm). See FRONT ROTOR RESURFACING SPECIFICATIONS table.

FRONT ROTOR RESURFACING SPECIFICATIONS ⁽¹⁾

Operation

Rough Cut

Finish Cut

Spindle Speed

150 RPM

Depth Of Cut ⁽²⁾

.006-.025"

.004-.006"

Depth Of Cut ⁽²⁾

(.15-.64 mm)

(.10-.15 mm)

Cross Feed ⁽³⁾

.010" (.25 mm)

.002" (.05 mm)

Vibration Damper

Yes

Non-Directional Finishing

N/A

⁽⁴⁾

⁽¹⁾	Manufacturer does not recommend resurfacing rotors when replacing brake pads. Resurface rotors only when there is a brake pulsation complaint or scoring greater than .060" (1.5 mm).

⁽²⁾	Per rotor side.

⁽³⁾	Per revolution.

⁽⁴⁾

With rotor still mounted on brake lathe, use a power sanding disc with 120 grit aluminum oxide sandpaper held for a minimum of 60 seconds on each side of rotor. A sanding block with 150 grit aluminum oxide sandpaper may be used in place of a power sanding disc. After sanding rotor, clean surface with denatured alcohol.