Brake Booster - Hydro-Boost: Installation

Mount booster to dash panel by sliding push rod through hole in dash panel. Install attaching nuts loosely, tighten after completing steps inside vehicle.
Install master cylinder on booster unit, tighten nuts. Position push rod on service brake pedal arm and install washer and retainer. Remove plugs and attach fluid lines to booster unit.
Fill power steering reservoir. Disconnect 12-volt wire from injection pump and engage starter. Do not start vehicle. Check power steering fluid level, and top off, if necessary. Install 12-volt wire to injection pump and start engine; then cycle steering wheel twice.
Stop engine and discharge accumulator by depressing brake pedal 4 or 5 times. Check power steering level. Top off, if necessary. Start engine, cycle steering wheel once, and turn engine off. Check fluid level. If foaming occurs, wait 1 hour and recheck level.