No Low Fuel Tone
- Unplug 6 wire connector near fuel tank. Connect rheostat leads from Tester (J-33431-A) between Pink wire in male half and ground. Set resistance to 4 ohms. Start engine. After 15 seconds, low fuel tone should sound.
- If system does not respond as specified, remove left hand sound absorber located above brake pedal. Start engine. After 15 seconds, set resistance on tester to 86 ohms.
- Using digital voltmeter, check voltage at Tan/Black wire of chimes/voice module. Module is located in center of instrument panel under radio. Voltmeter should read charging system voltage. Turn off engine. Set tester resistance to 4 ohms. Start engine. After 15 seconds, reading should be 0-1.5 volts.
- If readings are as specified in step 3), replace chimes/voice module. If not, shut off engine. Remove left front speaker cover. Disconnect negative battery cable. Unplug cluster harness connector. Unplug chimes/voice module.
- Use an ohmmeter to check for opens or shorts between Tan/Black wire of module and pin H (Tan/Black wire) of harness connector. If wiring is good, replace cluster.