Constant -38° Displayed For Inside Ambient Air Temperature
NOTE:
A constant -38° is displayed when there is an open circuit in the inside ambient air temperature sensor circuit.
- Remove right front speaker cover. Check connections at inside ambient air temperature sensor. If good, disconnect negative battery cable. Unplug inside air temperature sensor connector.
- Connect jumper wire between both wires. Remove left front speaker cover. Unplug cluster harness connector. Using an ohmmeter, check for shorts and opens, between pins C (Dark Green wire) and U (Black wire).
- If wiring is good, remove jumper wire. Plug connector into inside air temperature sensor. Check resistance between pins C and U of cluster harness connector. Record resistance. Use thermometer and measure air temperature.
- Compare resistance and temperature to specifications. See Temperature Sensor Resistance chart. If resistances are as specified, replace cluster. If not, replace inside air temperature sensor.