LEMON Manuals: Even more car manuals for everyone
Home >> Oldsmobile >> 1982 >> Toronado 5.7L Eng VIN N >> Repair and Diagnosis >> Electrical >> Body Electrical >> Switches, Gauges & Instrument Panels OLDSMOBILE >> Testing >> Oil Pressure Gauge

Oil Pressure Gauge

  1. With ignition on, disconnect wire at sending unit. Gauge should read 60 psi. Ground sending unit wire. Gauge should read 0 psi. If gauge read correct psi, replace sending unit. If gauge did not read correct psi, remove gauge and check wiring from gauge connector to sending unit. Repair as necessary.
  2. If wiring is okay, connect 12 volts to 12 volt terminal on gauge. Ground other terminal. If gauge does not read 60 psi, replace gauge. If gauge reads 60 psi, connect a jumper wire from sending unit terminal on gauge to ground terminal.
  3. If gauge does not read 0 psi, replace gauge. If gauge reads 0 psi, check circuit board and gauge connectors for open circuit.
scientia non olet · About LEMON Manuals