Camshaft Bearings: Installation
To install camshaft bearings, reverse removal procedure while noting the following: To aid in aligning bearings with oil passages, place bearing in front bore with tapered edge toward block and align oil hole in bearing with center of oil slot in bore. Mark top of bearing. When installing bearing, mark will act as a guide.
VALVE TIMING
| Engine | INTAKE | EXHAUST | ||
|---|---|---|---|---|
| Open (BTDC) | Close (ABDC) | Open (BBDC) | Close (ATDC) | |
| 260" | 14° | 48° | 56° | 14° |
| 350" | 16° | 54° | 64° | 20° |
| 455" | 20° | 58° | 68° | 24° |