Diagnosis Procedure

1. Ignition switch OFF.
2. Disconnect each rear combination lamp connector.
3. Check continuity of each tail lamp terminals.
   Body side
   
   

   Rear combination lamp (body side)		Continuity
   Terminals
   2	4	No

   Trunk lid side
   
   

   Rear combination lamp (trunk lid side)		Continuity
   Terminals
   1	4	No

Is the inspection result normal?

YES

Inspection End.

NO

GO TO 2.

1. Remove stop/tail lamp bulb and tail lamp bulb.
2. Check continuity of each tail lamp terminals.
   Body side
   
   

   Rear combination lamp (body side)		Continuity
   Terminals
   2	4	No

   Trunk lid side
   
   

   Rear combination lamp (trunk lid side)		Continuity
   Terminals
   1	4	No

Is the inspection result normal?

YES

Body side: Replace the corresponding stop/tail lamp bulb. Refer to Bulb Replacement .

YES

Trunk lid side: Replace the corresponding tail lamp bulb. Refer to Bulb Replacement .

NO

Repair or replace the each tail lamp bulb socket or harness.