Diagnosis Procedure

Check the front fog lamp.

Is the inspection result normal?

YES

GO TO 2.

NO

Replace the corresponding front fog lamp. Refer to Removal and Installation .

CONSULT

1. Ignition switch ON.
2. Select "FRONT FOG LAMP" in "Active Test" mode of "IPDM E/R".
3. With operating the test items, check voltage between IPDM E/R harness connector and ground.

   +			-	Test item		Voltage (Approx.)
   IPDM E/R
   Connector		Terminal
   RH	E44	57	Ground	FRONT FOG LAMP	On	Battery voltage
   					Off	0 V
   LH	E48	51			On	Battery voltage
   					Off	0 V

Is the inspection result normal?

YES

GO TO 3.

NO

Replace IPDM E/R. Refer to Removal and Installation .

1. Ignition switch OFF.
2. Disconnect IPDM E/R connector and front fog lamp connector.
3. Check continuity between IPDM E/R harness connector and front fog lamp harness connector.

   IPDM E/R			Front fog lamp		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E44	57	E82	1	Yes
   LH	E48	51	E303

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness.

Check continuity between front fog lamp harness connector and ground.

Is the inspection result normal?

YES

Check intermittent incident. Refer to Intermittent Incident .

NO

Repair or replace harness.