Diagnosis Procedure

CONSULT

1. Ignition switch ON.
2. Turn lighting switch 1ST.
3. Select "DAYTIME RUNNING LIGHT" in "Active Test" mode of "IPDM E/R".
4. With operating the test items, check voltage between IPDM E/R harness connector and ground.

   +			-	Test item		Voltage (Approx.)
   IPDM E/R
   Connector		Terminal
   RH	E44	58	Ground	DAYTIME RUNNING LIGHT	On	Battery voltage
   					Off	0 V
   LH	E48	49			On	Battery voltage
   					Off	0 V

Is the inspection result normal?

YES

GO TO 2.

NO

Replace IPDM E/R. Refer to Removal and Installation .

1. Ignition switch OFF.
2. Turn lighting switch OFF.
3. Disconnect IPDM E/R connector and front combination lamp connector.
4. Check continuity between IPDM E/R harness connector and front combination lamp harness connector.

   IPDM E/R			Front combination lamp		Continuity
   Connector		Terminal	Connector	Terminal
   RH	E44	58	E38	5	Yes
   LH	E48	49	E37

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

Check continuity between front combination lamp harness connector and ground.

Is the inspection result normal?

YES

Replace the corresponding front combination lamp. Refer to Removal and Installation .

NO

Repair or replace harness.